Hoses or cables running over the edge of a pond can spoil the ponds appearance.Hide your pond connections to create a professional finish. This Oase Tradux fitting provides truly wonderful finishing touch to provide below the waterline watertight transition for cables or hose pipe. The Tradux set makes an underwater exit for your pump's electrical cable or hose easy .Tradux kit can be used on all pond liner, any preformed plastic or fibreglass ponds or any material up to 12mm in thickness. The screw couplings allow the Tradux connector to be easily fitted and produce a secure waterproof and clean seal. The rubber gasket ensures a watertight seal. Technical specification For use with the following hose sizes: 12.5, 20, 25, 32, 38mm (2", 1 1/2", 1 1/4", 1", 3/4" inch) For use with cables sizes: 3mm to 9 mm diameter Diameter: 115 mm Maximum length (when using 3/4" hose on both sides): 335 mm Materials: Plastic body, EPDM rubber seal and bung, Stainless steel bolts Maximum transition thickness opening for cable use: 30 mm Maximum transition thickness opening for pipe use: 10 mm Below we show how to install a Tradux fitting for liner or reservoir transition. Below we show how to install a Tradux fitting for cable. Note one Tradux fitting is required per cable. Please note you can use this fitting for either purpose but not both at same time.